Image 1 of 1
Image 1 of 1
Image 1 of 1
Image 1 of 1
Everything you need to create the Classic DIY Vent out of your engineered or LVP flooring.
Two Hole Template - Pick two standard sizes. These are the approximate sizes of the duct you are working with. See our size guide for more information.
Two Vent Templates - These will match the two sizes on the two hole template that you select.
5 Pack of Vent Support Plates (if applicable) - These support plates are for LVP flooring only. These plates are oversized to accommodate multiple vent sizes. See our size guide for more information. Additional Vent Support Plates are available for purchase.
3 Plunge Router Bits - These are 1/4” bits used to cut into the flooring around the duct, as well and cutting the vents.
Bushing - This is the guide that attaches to your plunge router that follows the edges of the templates.
1 Roll of Double Sided Tape - Used to stick the Vent Template to the flooring when routing the vent.
Everything you need to create the Classic DIY Vent out of your engineered or LVP flooring.
Two Hole Template - Pick two standard sizes. These are the approximate sizes of the duct you are working with. See our size guide for more information.
Two Vent Templates - These will match the two sizes on the two hole template that you select.
5 Pack of Vent Support Plates (if applicable) - These support plates are for LVP flooring only. These plates are oversized to accommodate multiple vent sizes. See our size guide for more information. Additional Vent Support Plates are available for purchase.
3 Plunge Router Bits - These are 1/4” bits used to cut into the flooring around the duct, as well and cutting the vents.
Bushing - This is the guide that attaches to your plunge router that follows the edges of the templates.
1 Roll of Double Sided Tape - Used to stick the Vent Template to the flooring when routing the vent.